Review LCT 640 TS
We want to thank Andrea Rocca for publishing this super informative and revealing review about studio life with the LCT 640 TS. Andrea tested the microphone while recording acoustic guitar, vocals, bongo, eggshakers as well as a fuzzy electric guitar. The review is a good example for the versatility of the microphone and for all the possibilities the LCT 640 TS offers.
"It's safe to say that microphone design has never been the most forward looking segment of studio engineering. That might be because microphones that performed brilliantly appeared relatively quickly in the history of recording technology, and when those microphone acquired legendary statuses many designer's goals concentrated towards emulating those iconic sounds. It's also because as studio heads we tend to be traditionalists and stick to things we know or that we have seen other people using successfully... However a few companies have come up whose philosophy is to use modern technology to break new ground into what can be done with microphone performance.
The microphone I have here right now is the new LCT 640 TS, an offspring of LEWITT's best selling multi pattern LCT 640 but with a some very special capabilities. The LCT 640 TS is a dual capsule microphone but not in the conventional sense: the signal from each capsule can be recorded separately and combined offline (courtesy of a bespoke plugin called the Polarizer) to change the polar pattern response after the recording has been made. Yep.
The LCT 640 TS can also use the separate capsule circuits to easily make MS stereo recordings that do not need complicated decoding processes. So once again, we have something quite special from LEWITT on our hands.
The LCT 640 TS comes with an industrial grade heavy case, similar to the one that accompanies the flagship LCT 940, but about half the size.
Inside are the usual LEWITT style semicircle shock mount (very useful for placing the mic almost flush to the source should you want to do so), a mini XLR adapter with a Neutrik XLR on the other end, which is needed to use the mic in Dual Output Mode (DOM from now on), a soft padded pouch, the customary paperwork and a very welcome little accessory: a small magnetic, double meshed popper stopper that clicks in place over the shock mount.
This is a great solution since the popper stopper is one of those items that are a nightmare to carry around as they tend to break or tear very easily. My only worry was that, being so close to the grille, it might not be effective enough in preventing plosives, but after having used it for a few days it has proved itself to work perfectly well. It even stays on if you like to mount the mic upside down. LEWITT, please make a larger one for the 940!
At a first glance the LCT 640 TS looks pretty much the same as it's siblings from the LEWITT stable, except from the gargantuan sized LCT 940. It's large enough not to deflate vocalists' egos but also light enough not to make mic stands droop when placed in akward positions or when mounted on an amp clamp such as the Wishbone Hook v.2 I've mostly been using with it for recording electric guitar (see photo). The construction is reassuringly tough with a dense zinc body and a very solid grille.
In terms of specs the LCT 640 TS shows 11 dB(A) measured in cardioid, not quite close to the theoretical 0 of the LCT 550 but absolutely fine for any real-world scenario. Max SPL is a good 132 dB, and that's without using the pre-attenuation options.
The familiar buttons and illuminated leds select and highlight the high pass filters, set at 40, 80 and 160 Hz, the five multiple polar patterns (omni, wide cardioid, cardioid, super cardioid, and figure of 8) and the trademark LEWITT's Key Lock and Clipping History functions."
The sound of the LCT 640 TS:
“Testing it as a "normal" microphone the LCT 640 TS has the family LEWTT sound that I got to know and love: clear, detailed, true to the source and yet somewhat flattering and most importantly devoid of harshness or sibilance. Compared to the LEWITT condensers I have here the LCT 640 TS is slightly warmer than my LCT 550s, a mic whose main strength is the almost inexistent self noise and amazing transient response - and somewhat similar to the 940 in FET mode, which is to say very detailed but with a certain heft - obviously with some differences due to the smaller size of the basket. It doesn't sound quite as big on vocals as the LCT 940 with some of the valve dialed in but it's very much in the same ballpark. The LCT 940 has quickly become my to go microphone for vocals and most solo instruments so that is a very encouraging start. Just like with the 940, the polar patterns sound solid and well defined.”
In order to operate the LCT 640 TS in Dual Output Mode (DOM) the mini XLR adaptor has to be plugged in and phantom power applied to both capsules. Needless to say that you will need a stereo preamp. The capsules will take about twenty seconds to charge. Then the centre button has to be pressed for two seconds - the green triangular logo illuminates to show that the mic is in DOM, and the polar pattern indicators are, of course, disabled. You have to make sure that the gain on both channel is matched, which is easier to do accurately with digitally controlled preamps such as the ones on my Metric Halo ULN-8, but in practice I have found it to be no problem when working with all analogue preamps. Just like the polar patterns in "normal" mode DOM is remembered after phantom power has been switched off so the operation must not be repeated each time the mic is powered on. The mini XLR adaptor does not click in but its fit is more than solid enough to avoid having to worry about it coming off. The tiny LEWITT logo on it acts as a visual indicator (it has to face forward) so that connecting it in a dimly lit environment is not a problem.
When the mic is on the shock mount the adaptor will be placed between one of it's two plastic elements. It is very important to remember to remove the adaptor before taking the microphone out of the shock mount, otherwise there is a serious risk of straining the Mini XLR connector.
I kept the 40 Hz filter on for all of my tests, as it doesn't prevent the good juices from flowing into the sweet music but it stops unwanted sonic sludge crawling up mic stands and amp cabs. This is something I would always recommend to do - unless you're attempting to record the Brown Note , or the Song of Perseus - in which case you're on your own, kid...
All the samples are 44.1 Khz, 24 bit Wavs, the cables used were Van Damme XKE, and the preamps are specified on a per example basis
Andrea recorded in demand session guitarist Nico Sabatini on a handmade Patrick Eggle Etowa 000 acoustic. When auditioning the takes, Nico said that that is the sound he hears in his head when recording acoustic guitar...
The preamp used on Nico's recordings is an Audient asp 880.
This is a take recorded in stereo, simply tilting the microphone on it's side.
Andrea Rocca Music – Lewitt LCT 640 TS Nico Sabatini Stereo
On this take the Polarizer plugin does a sweep through all the different patterns - Omni (0.0), Cardioid (0.12), Figure of 8 (0:24), Back Cardioid (0:35) and back to Omni (0:44)
Andrea Rocca Music – Lewitt LCT 640 TS Nico Sabatini Pattern Sweep
Next, Andrea recorded some finger picking in stereo:
And a take with an automated pattern sweep: Omni (0:0), Cardioid (0:8), Figure of 8 (0:14), Rear Cardioid (0:20), Omni (0:24).
Andrea worked on a track "with the brilliant Elvin Brandhi, and set some time aside to record a snippet for this review. I really like how the figure of 8 brings out the chest details in her voice, but the other two patterns sounds great too, full, detailed, natural and present.
For these takes I used a Drawmer 1960 with a touch of compression - a couple of dbs on peaks"
Next to vocals, bongo, eggshakers, as well as electric guitar, Andrea recorded the sub octave fuzz sound courtesy of the Catalinbread Perseus, where a husky voiced black hole emits the lowest sound recorded, so far, in the Universe: 57 octaves below B-flat. "It's not an easy sound to grab, my dynamic mics tend to feature just the bigness without the rasp, my ribbons even more so. The LCT 640 TS captured a monster sound in all its might. Granted, it won't be everybody's favourite tone, but that makes me like it even more...
For this take I took the LCT 640 TS off the amp clamp and placed it on a stand about a metre away from the amp.The chain was: Vox Snake Charmer compressor > Catalinbread Perseus > Catalinbread Dirty Little Secret MkIII > Xotic Effects EP Booster > Eventide TimeFactor > Fender Deluxe Reverb Reissue.
"The LCT 640 TS will be particularly appreciated by those who see writing and recording as part of one organic creative process. There are so many things I haven't tried yet that I'm looking forward to do with this microphone. Automating the pattern response can be used during a mix as a more natural alternative to eq. Keep a part on omni, or even use the back capsule to make it sink into the mix and turn it to figure of 8 to bring it to the fore in the chorus... Very interesting and exciting stuff.
For someone like me, who often works for productions where sounds that come off the beaten path are highly desirable - such as scoring for contemporary dance companies - what can be done with this mic is invaluable: applying different effects to the two capsules whilst tracking, experimenting with compression on the ambiance whilst keeping the main signal close and focussed, working creatively on the stereo image....
It’s also perfect for those who record themselves or have to be both the producer and engineer, which means many of us. The things you can do with this microphone would be very hard and long winded to replicate with a different setup. It allows to keep options open and not having to run between the recording and control rooms, which is a real vibe killer.
Having someone popping into the recording room for changing a polar pattern at the last moment is a real downer, and quite disrespectful, for an artist that has just switched his/ her brain to performance mode.
Then there are the stereo capabilities: MS recording can be a real chore to do in the conventional way, which is why it was never part of my recording routines - until now.
And flipping the mic on it's side to do a stereo take is definitely more endearing during a busy session than having to rig in a second mic.
It would also make the perfect “travel” mic for those who need to travel light - a microphone to bring on location with which you can do just about anything.
And of course it's also a great tool for larger studios and engineers who want to keep their options open until the mix phase.
The LCT 640 TS is not only a box of tricks though. It’s also, and perhaps in the first place, a very, very good sounding microphone that you can throw at just about anything trusting that you will get a great result.”
Read the full version of the review at gearslutz.com - it provides numerous sound samples. All copyright credits are owned by Andrea Rocca.
About the Author: Andrea Rocca is a composer for the media and specialized in film and contemporary dance theatre music. From 2004 to 2010 he composed extensively for UK television, with works for Channel4, BBC1, BBC2 and Channel 5. In 2010 he scored Luigi Lo Cascio’s award winning theatre production La Caccia and the contemporary dance production Frames for Toronto based company Zata Omm Dance Projects. To date his feature film work includes the British feature The Hurting, Francesco Martinotti’s Branchie, Marco Risi’s L’Ultimo Capodanno and Tre Mogli, and Gianluca Tavarelli’s Liberi (Break Free), which run at the 2003 Venice Film Festival. He has recently completed the score for Luigi Lo Cascio’s La Città Ideale (The Ideal City), which was premiered at the 69th Venice International Film Festival, where it won the Arca Cinema award.
LCT 640 TS
- Full, crisp, and well-balanced sound
- Revolutionary Dual Output Mode
- POLARIZER plugin to create any pattern after the fact
- Stereo capabilities
- Multi-pattern design